top of page

No Heat? Check These 7 Things Before You Call for Service

KMG Mechanical
Oct 27
4 min read

There is nothing quite like waking up to a cold house in a New Hampshire winter. Sometimes it means a failed part and a service call. But a surprising number of no heat problems come down to something simple that a homeowner can check in a few minutes.

Before you pick up the phone, run through the checklist below. If one of these fixes it, great. If not, you will have useful information for your technician, which can mean a faster repair.

Safety first: if you smell gas, or your carbon monoxide alarm is going off, skip this list. Get everyone out of the house and call 911 or your gas or propane supplier from outside. Do not use light switches or phones inside.

1. Check the Thermostat

Make sure it is set to Heat, not Off or Cool, and that the temperature setting is a few degrees above the current room temperature. If the screen is blank or dim, replace the batteries. If you have a programmable or smart thermostat, check that a schedule or away setting has not lowered the temperature without you noticing.

2. Check the Breaker and the Service Switch

Your heating system needs power to run, even if it burns oil, gas, or propane. Look at your electrical panel for a tripped breaker labeled furnace, boiler, or burner. Then find the service switch. It is usually a light switch with a red cover plate, often at the top of the basement stairs or on or near the equipment. It is easy to bump off by accident, and it looks just like a regular light switch. Make sure it is on.

3. Check Your Fuel Supply

If you heat with oil or propane, check the gauge on your tank. Running out happens more often than people think, especially during a cold snap or a delivery delay. If you are out, call your fuel supplier first. Keep in mind that an oil system that ran dry often needs a technician to restart it, and after a propane tank runs empty, your supplier will typically need to perform a leak check before service is restored. If you have natural gas, check whether your other gas appliances, like the stove, are working.

4. Check the Furnace Filter

If you have a forced air furnace, a badly clogged filter can cause the system to overheat and shut itself off as a safety measure. Pull the filter and look at it. If it is gray and caked with dust, replace it. Many homes should change filters every one to three months during heating season.

5. Make Sure the Furnace Door Is On Tight

Most furnaces have a safety switch behind the lower front panel. If that panel is loose or not fully seated, perhaps after a filter change, the furnace will not run. Make sure the door is pushed in and secured all the way.

6. Check the Outdoor Vents and Condensate Drain

High efficiency furnaces and boilers usually vent through white plastic pipes on an outside wall. Snow, ice, leaves, or even a bird nest can block them and shut the system down. Carefully clear anything covering the pipes. These systems also produce water. If the condensate drain line or small pump is clogged or full, the system may stop running until it is cleared.

7. Press the Oil Burner Reset Button Once, and Only Once

Oil burners have a red reset button on the control. If your oil system has locked out, you can press the reset one time. If the burner does not start and stay running, do not keep pressing it. Every press can send more oil into the combustion chamber, which can create a dangerous condition and a much more expensive repair. One press, then call.

When to Stop and Call for Service

Call a licensed technician if any of the following happen: the system still will not run after this checklist, the oil burner locks out again, you see water leaking, you notice a burning or fuel smell, or the equipment shows a flashing light or error code. Do not remove panels beyond the filter door or try to relight a burner yourself.

Before you call, jot down a few details: what the thermostat says, any flashing light pattern or error code, any noises you heard before it quit, and roughly when it stopped. That information helps your technician come prepared.

Prevent the Next No Heat Call

Many no heat calls can be avoided with annual maintenance. A yearly service catches worn parts, dirty components, and small problems before they leave you in the cold. If your system has not been serviced in the last year, now is the time.

We Are Here When You Need Us

KMG Mechanical is a locally owned, veteran owned heating and cooling company based in Rochester, NH. We service oil, gas, and propane furnaces and boilers for homeowners and small businesses throughout Strafford County, the Seacoast, the Lakes Region, and Southern Maine.

If you have no heat, or you want to get ahead of it with annual maintenance, call us at (603) 919-7929 or request service at www.kmgmechanical.org.

KMG Mechanical (603) 919-7929 www.kmgmechanical.org YOUR COMFORT IS OUR COMMITMENT


 
 
 

Comments


bottom of page